Yes, the hub is identical
Same 5x114.3 PCD and same 64.1 mm centre bore: wheels from Acura 3.5 RL bolt on and centre on Honda Element without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Acura 3.5 RL is compared with the one from Honda Element of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈7Jx16 ET55 · 215/60R16 — Check on the car
Compared with the original 6.5Jx16 ET45 on Honda Element: shock absorber side +16.4 mm, wheel arch side −3.7 mm, tyre diameter −6.1 % : fit it with the original tyre size of Honda Element (215/70R16), not that of Acura 3.5 RL.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Honda Element (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Honda Element on Acura 3.5 RL?