FRENES

Wheels from Audi S3 on Dodge Neon SRT4: compatible?

Yes, the hub is identical

Same 5x100 PCD and same 57.1 mm centre bore: wheels from Audi S3 bolt on and centre on Dodge Neon SRT4 without rings. You still need to check the offset and tyres, detailed below.

Audi S31999–2003Dodge Neon SRT42003–2005
PCD5x100 / 5x1125x100
Centre bore57.1 mm57.1 mm
ThreadM14x1.50Ecrous - 12x1.50
Original wheels R
R
≈6.5Jx17 ET49
≈7Jx18 ET46		 ≈6.5Jx17 ET45

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Audi S3 is compared with the one from Dodge Neon SRT4 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈6.5Jx17 ET49 · 205/50R17 — Check on the car

    Compared with the original ≈6.5Jx17 ET45 on Dodge Neon SRT4: shock absorber side +4 mm, wheel arch side −4 mm, tyre diameter +0 %. Comparison for guidance only (estimated width). Check in detail

  • ≈7Jx18 ET46 · 225/40R18

    Dodge Neon SRT4 has no 18-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Dodge Neon SRT4 (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Dodge Neon SRT4 on Audi S3?