Yes, the hub is identical
Same 5x112 PCD and same 66.5 mm centre bore: wheels from Audi SQ8 bolt on and centre on BMW i8 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Audi SQ8 is compared with the one from BMW i8 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈8.5Jx20 ET20 · 265/50R20 — Check on the car
Compared with the original 7Jx20 ET36 on BMW i8: shock absorber side +3.1 mm, wheel arch side +35.1 mm, tyre diameter +10 % : fit it with the original tyre size of BMW i8 (195/50R20), not that of Audi SQ8.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of BMW i8 (M14x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from BMW i8 on Audi SQ8?