Yes, the hub is identical
Same 5x120 PCD and same 72.5 mm centre bore: wheels from BMW M5 F10 bolt on and centre on Bentley Brooklands without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from BMW M5 F10 is compared with the one from Bentley Brooklands of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
9Jx19 ET32 · 265/40R19 — Check on the car
Compared with the original ≈8Jx19 ET47 on Bentley Brooklands: shock absorber side −2.3 mm, wheel arch side +27.7 mm, tyre diameter −2.5 % : fit it with the original tyre size of Bentley Brooklands (255/45R19), not that of BMW M5 F10.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Bentley Brooklands (Ecrous - 14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Bentley Brooklands on BMW M5 F10?