Yes, with hub centric rings
Same 5x120 PCD, but the centre bore of the wheels from Chevrolet Camaro (70.3 mm) is larger than the hub of Opel Insignia OPC (67.1 mm): you need 4 hub centric rings 70.3 → 67.1.
Rings 70.3 → 67.1
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Chevrolet Camaro is compared with the one from Opel Insignia OPC of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈7.5Jx18 ET32 · 245/50R18 — Fits like the original
Compared with the original 8Jx18 ET41 on Opel Insignia OPC: shock absorber side −15.4 mm, wheel arch side +2.7 mm, tyre diameter +5 % : fit it with the original tyre size of Opel Insignia OPC (235/45R18), not that of Chevrolet Camaro.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Opel Insignia OPC (Ecrous - 14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Opel Insignia OPC on Chevrolet Camaro?