Yes, the hub is identical
Same 5x112 PCD and same 57.1 mm centre bore: wheels from Cupra Formentor bolt on and centre on Aiways U5 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Cupra Formentor is compared with the one from Aiways U5 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈7Jx17 ET40 · 225/55R17 — Fits like the original
Compared with the original ≈7Jx17 ET40 on Aiways U5: shock absorber side 0 mm, wheel arch side 0 mm, tyre diameter −4.5 % : fit it with the original tyre size of Aiways U5 (215/65R17), not that of Cupra Formentor.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Aiways U5 (-), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Aiways U5 on Cupra Formentor?