FRENES

Wheels from Dacia Sandero III on Alpine GTA axe arrière: compatible?

Yes, the hub is identical

Same 4x100 PCD and same 60.1 mm centre bore: wheels from Dacia Sandero III bolt on and centre on Alpine GTA axe arrière without rings. You still need to check the offset and tyres, detailed below.

Dacia Sandero IIIfrom 2020Alpine GTA axe arrière1985–1991
PCD4x1004x100
Centre bore60.1 mm60.1 mm
ThreadM12x1.50Ecrous - 12x1.50
Original wheels 6Jx15 ET40 ≈8Jx15 ET20

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Dacia Sandero III is compared with the one from Alpine GTA axe arrière of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 6Jx15 ET40 · 185/65R15 — Fits like the original

    Compared with the original ≈8Jx15 ET20 on Alpine GTA axe arrière: shock absorber side −5.4 mm, wheel arch side −45.4 mm, tyre diameter +1.8 %. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Alpine GTA axe arrière (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Alpine GTA axe arrière on Dacia Sandero III?