FRENES

Wheels from Fiat Fiorino on Lada 1200: compatible?

Yes, the hub is identical

Same 4x98 PCD and same 58.1 mm centre bore: wheels from Fiat Fiorino bolt on and centre on Lada 1200 without rings. You still need to check the offset and tyres, detailed below.

Fiat Fiorino1989–2001Lada 12001970–1988
PCD4x984x98
Centre bore58.1 mm58.1 mm
ThreadM12x1.25M12x1.25
Original wheels ≈5Jx13 ET44
≈5.5Jx14 ET44		 ≈5Jx13 ET29

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Fiat Fiorino is compared with the one from Lada 1200 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈5Jx13 ET44 · 165/70R13 — Check on the car

    Compared with the original ≈5Jx13 ET29 on Lada 1200: shock absorber side +15 mm, wheel arch side −15 mm, tyre diameter −2.9 % : fit it with the original tyre size of Lada 1200 (155/80R13), not that of Fiat Fiorino. Comparison for guidance only (estimated width). Check in detail

  • ≈5.5Jx14 ET44 · 175/70R14

    Lada 1200 has no 14-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Lada 1200 (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Lada 1200 on Fiat Fiorino?