Yes, the hub is identical
Same 5x114.3 PCD and same 60.1 mm centre bore: wheels from Fiat Sedici bolt on and centre on Toyota Auris I without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Fiat Sedici is compared with the one from Toyota Auris I of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈6.5Jx15 ET50 · 205/65R15 — Check on the car
Compared with the original 6Jx15 ET39 on Toyota Auris I: shock absorber side +17.4 mm, wheel arch side −4.6 mm, tyre diameter +2 % : fit it with the original tyre size of Toyota Auris I (195/65R15), not that of Fiat Sedici.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Toyota Auris I (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Toyota Auris I on Fiat Sedici?