Yes, the hub is identical
Same 5x114.3 PCD and same 64.1 mm centre bore: wheels from Honda e:Ny1 bolt on and centre on Tesla Model 3 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Honda e:Ny1 is compared with the one from Tesla Model 3 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈7Jx18 ET55 · 225/50R18 — Fits like the original
Compared with the original 8.5Jx18 ET40 on Tesla Model 3: shock absorber side −4.1 mm, wheel arch side −34.1 mm, tyre diameter +2 % : fit it with the original tyre size of Tesla Model 3 (235/45R18), not that of Honda e:Ny1.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Tesla Model 3 (Ecrous - 14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Tesla Model 3 on Honda e:Ny1?