Yes, the hub is identical
Same 5x114.3 PCD and same 64.1 mm centre bore: wheels from Honda e bolt on and centre on Acura 3.5 RL without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Honda e is compared with the one from Acura 3.5 RL of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
6Jx16 ET50 · 185/60R16 — Fits like the original
Compared with the original ≈7Jx16 ET55 on Acura 3.5 RL: shock absorber side −17.7 mm, wheel arch side −7.7 mm, tyre diameter −5.4 % : fit it with the original tyre size of Acura 3.5 RL (215/60R16), not that of Honda e.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Acura 3.5 RL (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Acura 3.5 RL on Honda e?