Yes, the hub is identical
Same 4x100 PCD and same 54.1 mm centre bore: wheels from Hyundai Getz bolt on and centre on Daihatsu Trevis without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Hyundai Getz is compared with the one from Daihatsu Trevis of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈5Jx13 ET46 · 155/80R13 — Check on the car
Compared with the original ≈4.5Jx13 ET40 on Daihatsu Trevis: shock absorber side +12.4 mm, wheel arch side 0 mm, tyre diameter +2.8 % : fit it with the original tyre size of Daihatsu Trevis (145/80R13), not that of Hyundai Getz.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Daihatsu Trevis (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Daihatsu Trevis on Hyundai Getz?