Yes, the hub is identical
Same 4x100 PCD and same 54.1 mm centre bore: wheels from Hyundai i10 I bolt on and centre on Hyundai Getz Cross without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Hyundai i10 I is compared with the one from Hyundai Getz Cross of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈5Jx14 ET46 · 165/60R14 — Fits like the original
Compared with the original ≈5Jx14 ET46 on Hyundai Getz Cross: shock absorber side 0 mm, wheel arch side 0 mm, tyre diameter −2.9 % : fit it with the original tyre size of Hyundai Getz Cross (165/65R14), not that of Hyundai i10 I.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Hyundai Getz Cross (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Hyundai Getz Cross on Hyundai i10 I?