FRENES

Wheels from Kia Ceed III on Mitsubishi Lancer 2.0i: compatible?

Yes, the hub is identical

Same 5x114.3 PCD and same 67.1 mm centre bore: wheels from Kia Ceed III bolt on and centre on Mitsubishi Lancer 2.0i without rings. You still need to check the offset and tyres, detailed below.

Kia Ceed IIIfrom 2018Mitsubishi Lancer 2.0i2003–2008
PCD5x114.35x114.3
Centre bore67.1 mm67.1 mm
ThreadM12x1.5Ecrous - 12x1.50
Original wheels 6Jx15 ET46
6.5Jx16 ET50
6.5Jx16 ET51
7Jx17 ET53
7.5Jx18 ET55		 ≈6Jx15 ET46

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Kia Ceed III is compared with the one from Mitsubishi Lancer 2.0i of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 6Jx15 ET46 · 195/65R15 — Fits like the original

    Compared with the original ≈6Jx15 ET46 on Mitsubishi Lancer 2.0i: shock absorber side 0 mm, wheel arch side 0 mm, tyre diameter +3.2 % : fit it with the original tyre size of Mitsubishi Lancer 2.0i (195/60R15), not that of Kia Ceed III. Comparison for guidance only (estimated width). Check in detail

  • 6.5Jx16 ET50 · 205/55R16

    Mitsubishi Lancer 2.0i has no 16-inch original wheel in our data: check the approved fitments and caliper clearance.

  • 6.5Jx16 ET51 · 205/55R16

    Mitsubishi Lancer 2.0i has no 16-inch original wheel in our data: check the approved fitments and caliper clearance.

  • 7Jx17 ET53 · 225/45R17

    Mitsubishi Lancer 2.0i has no 17-inch original wheel in our data: check the approved fitments and caliper clearance.

  • 7.5Jx18 ET55 · 225/40R18

    Mitsubishi Lancer 2.0i has no 18-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Mitsubishi Lancer 2.0i (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Mitsubishi Lancer 2.0i on Kia Ceed III?