Yes, the hub is identical
Same 5x114.3 PCD and same 67.1 mm centre bore: wheels from Kia XCeed bolt on and centre on Citroen C-crosser without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Kia XCeed is compared with the one from Citroen C-crosser of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
6.5Jx16 ET40 · 205/60R16 — Fits like the original
Compared with the original 6.5Jx16 ET38 on Citroen C-crosser: shock absorber side +2 mm, wheel arch side −2 mm, tyre diameter −7.8 % : fit it with the original tyre size of Citroen C-crosser (215/70R16), not that of Kia XCeed.
Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Citroen C-crosser (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Citroen C-crosser on Kia XCeed?