FRENES

Wheels from Lotus Emira back on Aston Martin DBS axe arrière: compatible?

Yes, the hub is identical

Same 5x114.3 PCD and same 68.1 mm centre bore: wheels from Lotus Emira back bolt on and centre on Aston Martin DBS axe arrière without rings. You still need to check the offset and tyres, detailed below.

Lotus Emira backfrom 2022Aston Martin DBS axe arrière2007–2012
PCD5x114.35x114.3
Centre bore68.1 mm68.1 mm
ThreadM12x1.50Ecrous - 14x2.00
Original wheels ≈9.5Jx20 ET54 ≈9.5Jx20 ET54

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Lotus Emira back is compared with the one from Aston Martin DBS axe arrière of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈9.5Jx20 ET54 · 295/30R20 — Fits like the original

    Compared with the original ≈9.5Jx20 ET54 on Aston Martin DBS axe arrière: shock absorber side 0 mm, wheel arch side 0 mm, tyre diameter +0 %. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Aston Martin DBS axe arrière (Ecrous - 14x2.00), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Aston Martin DBS axe arrière on Lotus Emira back?