Yes, the hub is identical
Same 4x100 PCD and same 56.1 mm centre bore: wheels from MG MG3 bolt on and centre on Citroen C-Zero without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from MG MG3 is compared with the one from Citroen C-Zero of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈6Jx15 ET45 · 185/65R15 — Check on the car
Compared with the original 4Jx15 ET35 on Citroen C-Zero: shock absorber side +35.4 mm, wheel arch side +15.4 mm, tyre diameter +9.1 % : fit it with the original tyre size of Citroen C-Zero (145/65R15), not that of MG MG3.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Citroen C-Zero (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Citroen C-Zero on MG MG3?