Yes, the hub is identical
Same 4x100 PCD and same 56.1 mm centre bore: wheels from MG ZR bolt on and centre on Honda WR-V without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from MG ZR is compared with the one from Honda WR-V of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈6.5Jx16 ET45 · 205/50R16 — Check on the car
Compared with the original 6Jx16 ET53 on Honda WR-V: shock absorber side −1.6 mm, wheel arch side +14.4 mm, tyre diameter −4.5 % : fit it with the original tyre size of Honda WR-V (195/60R16), not that of MG ZR.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Honda WR-V (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Honda WR-V on MG ZR?