Yes, the hub is identical
Same 5x114.3 PCD and same 67.1 mm centre bore: wheels from Mitsubishi Lancer EVO X bolt on and centre on Suzuki E-Vitara without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Mitsubishi Lancer EVO X is compared with the one from Suzuki E-Vitara of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
8.5Jx18 ET38 · 245/40R18 — Check on the car
Compared with the original ≈7Jx18 ET45 on Suzuki E-Vitara: shock absorber side +12.1 mm, wheel arch side +26.1 mm, tyre diameter −7.3 % : fit it with the original tyre size of Suzuki E-Vitara (225/55R18), not that of Mitsubishi Lancer EVO X.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Suzuki E-Vitara (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Suzuki E-Vitara on Mitsubishi Lancer EVO X?