FRENES

Wheels from Nissan NV300 on Nissan Primastar: compatible?

No, the centre bore is too small

Same 5x114.3 PCD, but the centre bore of the wheels from Nissan NV300 (66.1 mm) is smaller than the hub of Nissan Primastar (71.1 mm): they will not fit without being re-bored by a professional.

Nissan NV300from 2017Nissan Primastar2001–2015
PCD5x114.35x118 / 5x114.3
Centre bore66.1 mm71.1 mm
ThreadM14x1.50M14x1.50
Original wheels 6Jx16 ET50 R
≈7Jx16 ET50

≈: width estimated from the original tyre size.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Nissan Primastar (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Nissan Primastar on Nissan NV300?