Yes, the hub is identical
Same 5x114.3 PCD and same 66.1 mm centre bore: wheels from Nissan X-Trail T32 bolt on and centre on Nissan Murano Z50 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Nissan X-Trail T32 is compared with the one from Nissan Murano Z50 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
7Jx17 ET45 · 225/65R17 — Check on the car
Compared with the original ≈7Jx17 ET40 on Nissan Murano Z50: shock absorber side +5 mm, wheel arch side −5 mm, tyre diameter −3 % : fit it with the original tyre size of Nissan Murano Z50 (225/70R17), not that of Nissan X-Trail T32.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Nissan Murano Z50 (Ecrous - 12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Nissan Murano Z50 on Nissan X-Trail T32?