FRENES

Wheels from Rolls-Royce Wraith on Alpina B4 axe avant: compatible?

Yes, the hub is identical

Same 5x120 PCD and same 72.6 mm centre bore: wheels from Rolls-Royce Wraith bolt on and centre on Alpina B4 axe avant without rings. You still need to check the offset and tyres, detailed below.

Rolls-Royce Wraithfrom 2013Alpina B4 axe avant2014–2019
PCD5x1205x120
Centre bore72.6 mm72.6 mm
ThreadM14x1.50M14x1.25
Original wheels ≈8Jx19 ET25 ≈7.5Jx19 ET36

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Rolls-Royce Wraith is compared with the one from Alpina B4 axe avant of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈8Jx19 ET25 · 255/50R19 — Check on the car

    Compared with the original ≈7.5Jx19 ET36 on Alpina B4 axe avant: shock absorber side −4.7 mm, wheel arch side +17.4 mm, tyre diameter +12.8 % : fit it with the original tyre size of Alpina B4 axe avant (245/35R19), not that of Rolls-Royce Wraith. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Alpina B4 axe avant (M14x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Alpina B4 axe avant on Rolls-Royce Wraith?