FRENES

Wheels from Skoda Enyaq on Volkswagen ID.Buzz axe avant: compatible?

Yes, the hub is identical

Same 5x112 PCD and same 57.1 mm centre bore: wheels from Skoda Enyaq bolt on and centre on Volkswagen ID.Buzz axe avant without rings. You still need to check the offset and tyres, detailed below.

Skoda Enyaqfrom 2020Volkswagen ID.Buzz axe avantfrom 2022
PCD5x1125x112
Centre bore57.1 mm57.1 mm
ThreadM14x1.50M14x1.50
Original wheels 8Jx18 ET45 8Jx18 ET45

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Skoda Enyaq is compared with the one from Volkswagen ID.Buzz axe avant of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 8Jx18 ET45 · 235/60R18 — Fits like the original

    Compared with the original 8Jx18 ET45 on Volkswagen ID.Buzz axe avant: shock absorber side 0 mm, wheel arch side 0 mm, tyre diameter +0 %. Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Volkswagen ID.Buzz axe avant (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Volkswagen ID.Buzz axe avant on Skoda Enyaq?