Yes, the hub is identical
Same 4x100 PCD and same 54.1 mm centre bore: wheels from Suzuki Celerio bolt on and centre on Daihatsu Sirion without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Suzuki Celerio is compared with the one from Daihatsu Sirion of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
5Jx14 ET45 · 165/65R14 — Check on the car
Compared with the original ≈4.5Jx14 ET40 on Daihatsu Sirion: shock absorber side +11.4 mm, wheel arch side +1.4 mm, tyre diameter −3 % : fit it with the original tyre size of Daihatsu Sirion (145/80R14), not that of Suzuki Celerio.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Daihatsu Sirion (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Daihatsu Sirion on Suzuki Celerio?