Yes, the hub is identical
Same 5x108 PCD and same 63.4 mm centre bore: wheels from Volvo EX40 axe arrière bolt on and centre on Volvo V60 II without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Volvo EX40 axe arrière is compared with the one from Volvo V60 II of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✕
8.5Jx19 ET56 · 255/45R19 — Risk of rubbing
Compared with the original 8Jx19 ET42 on Volvo V60 II: shock absorber side +20.4 mm, wheel arch side −7.7 mm, tyre diameter +6.2 % : fit it with the original tyre size of Volvo V60 II (235/40R19), not that of Volvo EX40 axe arrière.
Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Volvo V60 II (M14x1.5), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Volvo V60 II on Volvo EX40 axe arrière?