Yes, the hub is identical
Same 5x108 PCD and same 63.4 mm centre bore: wheels from Volvo EX40 axe avant bolt on and centre on Lynk&Co 08 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Volvo EX40 axe avant is compared with the one from Lynk&Co 08 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
7.5Jx19 ET50 · 235/50R19 — Fits like the original
Compared with the original ≈7.5Jx19 ET50 on Lynk&Co 08: shock absorber side 0 mm, wheel arch side 0 mm, tyre diameter −3.2 % : fit it with the original tyre size of Lynk&Co 08 (235/55R19), not that of Volvo EX40 axe avant.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Lynk&Co 08 (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Lynk&Co 08 on Volvo EX40 axe avant?