Yes, the hub is identical
Same 5x108 PCD and same 63.4 mm centre bore: wheels from Zeekr 001 bolt on and centre on Lynk&Co 02 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Zeekr 001 is compared with the one from Lynk&Co 02 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈8Jx19 ET40 · 255/55R19 — Check on the car
Compared with the original ≈7.5Jx19 ET47 on Lynk&Co 02: shock absorber side −0.7 mm, wheel arch side +13.4 mm, tyre diameter +6.3 % : fit it with the original tyre size of Lynk&Co 02 (235/50R19), not that of Zeekr 001.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Lynk&Co 02 (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Lynk&Co 02 on Zeekr 001?