Yes, the hub is identical
Same 4x98 PCD and same 58.1 mm centre bore: wheels from Abarth 595 bolt on and centre on Fiat Doblo without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Abarth 595 is compared with the one from Fiat Doblo of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈6Jx16 ET38 · 195/45R16 — Fits like the original
Compared with the original ≈6.5Jx16 ET36 on Fiat Doblo: shock absorber side −4.4 mm, wheel arch side −8.4 mm, tyre diameter −10.8 % : fit it with the original tyre size of Fiat Doblo (205/60R16), not that of Abarth 595.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Fiat Doblo (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Fiat Doblo on Abarth 595?