Yes, the hub is identical
Same 5x128 PCD and same 75.1 mm centre bore: wheels from Aston Martin Rapide AMR axe arrière bolt on and centre on Aston Martin Vantage axe arrière without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Aston Martin Rapide AMR axe arrière is compared with the one from Aston Martin Vantage axe arrière of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈9.5Jx20 ET48 · 295/35R20 — Check on the car
Compared with the original ≈9.5Jx20 ET55 on Aston Martin Vantage axe arrière: shock absorber side −7 mm, wheel arch side +7 mm, tyre diameter +0 %.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Aston Martin Vantage axe arrière (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Aston Martin Vantage axe arrière on Aston Martin Rapide AMR axe arrière?