FRENES

Wheels from BMW 7 Serie G70 on Alpina D3: compatible?

No, the centre bore is too small

Same 5x112 PCD, but the centre bore of the wheels from BMW 7 Serie G70 (66.6 mm) is smaller than the hub of Alpina D3 (72.6 mm): they will not fit without being re-bored by a professional.

BMW 7 Serie G70from 2022Alpina D32013–2019
PCD5x1125x120 / 5x112
Centre bore66.6 mm72.6 mm
ThreadM14x1.25M12x1.50
Original wheels 8.5Jx19 ET26 ≈7.5Jx19 ET36
≈8Jx19 ET28

≈: width estimated from the original tyre size.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Alpina D3 (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Alpina D3 on BMW 7 Serie G70?