FRENES

Wheels from BYD Dolphin on Suzuki S-Cross: compatible?

Yes, the hub is identical

Same 5x114.3 PCD and same 60.1 mm centre bore: wheels from BYD Dolphin bolt on and centre on Suzuki S-Cross without rings. You still need to check the offset and tyres, detailed below.

BYD Dolphinfrom 2021Suzuki S-Cross2013–2022
PCD5x114.35x114.3
Centre bore60.1 mm60.1 mm
ThreadM12x1.50M12x1.50
Original wheels ≈6Jx16 ET40 6Jx16 ET50
6.5Jx16 ET50

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from BYD Dolphin is compared with the one from Suzuki S-Cross of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈6Jx16 ET40 · 195/60R16 — Check on the car

    Compared with the original 6Jx16 ET50 on Suzuki S-Cross: shock absorber side −10 mm, wheel arch side +10 mm, tyre diameter −1.8 %. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Suzuki S-Cross (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Suzuki S-Cross on BYD Dolphin?