FRENES

Wheels from Dacia Duster III on Fiat Talento: compatible?

Yes, the hub is identical

Same 5x114.3 PCD and same 66.1 mm centre bore: wheels from Dacia Duster III bolt on and centre on Fiat Talento without rings. You still need to check the offset and tyres, detailed below.

Dacia Duster IIIfrom 2024Fiat Talentofrom 2016
PCD5x114.35x114.3
Centre bore66.1 mm66.1 mm
ThreadM12x1.5M14x1.50
Original wheels 6.5Jx16 ET32
6.5Jx17 ET32
6.5Jx17 ET36		 ≈6.5Jx16 ET50

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Dacia Duster III is compared with the one from Fiat Talento of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 6.5Jx16 ET32 · 215/70R16 — Check on the car

    Compared with the original ≈6.5Jx16 ET50 on Fiat Talento: shock absorber side −18 mm, wheel arch side +18 mm, tyre diameter +5.1 % : fit it with the original tyre size of Fiat Talento (205/65R16), not that of Dacia Duster III. Comparison for guidance only (estimated width). Check in detail

  • 6.5Jx17 ET32 · 215/65R17

    Fiat Talento has no 17-inch original wheel in our data: check the approved fitments and caliper clearance.

  • 6.5Jx17 ET36 · 225/60R17

    Fiat Talento has no 17-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Fiat Talento (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Fiat Talento on Dacia Duster III?