Yes, the hub is identical
Same 5x114.3 PCD and same 67.1 mm centre bore: wheels from Faw - Hongqi E-HS3 bolt on and centre on Mazda CX-80 without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Faw - Hongqi E-HS3 is compared with the one from Mazda CX-80 of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈7.5Jx18 ET50 · 235/50R18 — Check on the car
Compared with the original 7.5Jx18 ET45 on Mazda CX-80: shock absorber side +5 mm, wheel arch side −5 mm, tyre diameter −6.4 % : fit it with the original tyre size of Mazda CX-80 (235/60R18), not that of Faw - Hongqi E-HS3.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Mazda CX-80 (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Mazda CX-80 on Faw - Hongqi E-HS3?