FRENES

Wheels from Faw - Hongqi E-HS9 on Lamborghini Urus axe arrière: compatible?

Yes, the hub is identical

Same 5x130 PCD and same 71.6 mm centre bore: wheels from Faw - Hongqi E-HS9 bolt on and centre on Lamborghini Urus axe arrière without rings. You still need to check the offset and tyres, detailed below.

Faw - Hongqi E-HS9from 2020Lamborghini Urus axe arrièrefrom 2018
PCD5x1305x130
Centre bore71.6 mm71.6 mm
ThreadM14x1.50M14x1.50
Original wheels ≈8.5Jx21 ET48 ≈10Jx21 ET22

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Faw - Hongqi E-HS9 is compared with the one from Lamborghini Urus axe arrière of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈8.5Jx21 ET48 · 265/45R21 — Check on the car

    Compared with the original ≈10Jx21 ET22 on Lamborghini Urus axe arrière: shock absorber side +6.9 mm, wheel arch side −45.1 mm, tyre diameter −1.7 %. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Lamborghini Urus axe arrière (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Lamborghini Urus axe arrière on Faw - Hongqi E-HS9?