Yes, the hub is identical
Same 4x98 PCD and same 58.1 mm centre bore: wheels from Fiat Panda I bolt on and centre on Lada Priora without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Fiat Panda I is compared with the one from Lada Priora of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈5Jx13 ET35 · 155/80R13 — Fits like the original
Compared with the original ≈5.5Jx13 ET35 on Lada Priora: shock absorber side −6.3 mm, wheel arch side −6.3 mm, tyre diameter +0.5 %.
Comparison for guidance only (estimated width). Check in detail
- ?
≈5.5Jx14 ET35 · 175/65R14
Lada Priora has no 14-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Lada Priora (M12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Lada Priora on Fiat Panda I?