FRENES

Wheels from Ford Aerostar on Honda Accord: compatible?

Yes, the hub is identical

Same 5x114.3 PCD and same 64.1 mm centre bore: wheels from Ford Aerostar bolt on and centre on Honda Accord without rings. You still need to check the offset and tyres, detailed below.

Ford Aerostar1985–1997Honda Accord1982–1990
PCD5x114.34x100 / 4x114.3 / 5x114.3
Centre bore64.1 mm64.1 mm
ThreadEcrous - 12x1.50Ecrous - 12x1.50
Original wheels 6Jx14 ET10 R
≈6Jx14 ET50
≈6Jx15 ET55
≈6.5Jx16 ET45
≈7Jx17 ET45

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Ford Aerostar is compared with the one from Honda Accord of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 6Jx14 ET10 · 215/70R14 — Check on the car

    Compared with the original ≈6Jx14 ET50 on Honda Accord: shock absorber side −40 mm, wheel arch side +40 mm, tyre diameter +6.8 % : fit it with the original tyre size of Honda Accord (185/70R14), not that of Ford Aerostar. Comparison for guidance only (estimated width). Check in detail

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Honda Accord (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Honda Accord on Ford Aerostar?