Yes, the hub is identical
Same 5x114.3 PCD and same 67.1 mm centre bore: wheels from Ford Probe bolt on and centre on Mitsubishi FTO without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Ford Probe is compared with the one from Mitsubishi FTO of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈6Jx14 ET42 · 185/70R14 — Fits like the original
Compared with the original ≈6Jx14 ET46 on Mitsubishi FTO: shock absorber side −4 mm, wheel arch side +4 mm, tyre diameter +0 %.
Comparison for guidance only (estimated width). Check in detail
- ?
≈6.5Jx15 ET40 · 205/55R15
Mitsubishi FTO has no 15-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Mitsubishi FTO (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Mitsubishi FTO on Ford Probe?