Yes, the hub is identical
Same 4x100 PCD and same 56.6 mm centre bore: wheels from Holden Barina bolt on and centre on Chevrolet Nubira without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Holden Barina is compared with the one from Chevrolet Nubira of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈6Jx14 ET45 · 185/60R14 — Fits like the original
Compared with the original ≈6Jx14 ET49 on Chevrolet Nubira: shock absorber side −4 mm, wheel arch side +4 mm, tyre diameter −3.1 % : fit it with the original tyre size of Chevrolet Nubira (185/65R14), not that of Holden Barina.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Chevrolet Nubira (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Chevrolet Nubira on Holden Barina?