Yes, the hub is identical
Same 5x98 PCD and same 58.1 mm centre bore: wheels from Holden Combo bolt on and centre on Fiat Ulysse without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Holden Combo is compared with the one from Fiat Ulysse of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈6Jx15 ET39 · 185/65R15 — Check on the car
Compared with the original ≈6Jx15 ET31 on Fiat Ulysse: shock absorber side +8 mm, wheel arch side −8 mm, tyre diameter −2 % : fit it with the original tyre size of Fiat Ulysse (195/65R15), not that of Holden Combo.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Fiat Ulysse (M14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Fiat Ulysse on Holden Combo?