Yes, the hub is identical
Same 5x120 PCD and same 72.6 mm centre bore: wheels from Lamborghini Aventador bolt on and centre on Fisker Latigo CS without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Lamborghini Aventador is compared with the one from Fisker Latigo CS of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
12Jx20 ET57 · 335/30R20 — Check on the car
Compared with the original ≈8Jx20 ET10 on Fisker Latigo CS: shock absorber side +97.8 mm, wheel arch side +3.8 mm, tyre diameter +3.3 % : fit it with the original tyre size of Fisker Latigo CS (255/35R20), not that of Lamborghini Aventador.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Fisker Latigo CS (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Fisker Latigo CS on Lamborghini Aventador?