Yes, the hub is identical
Same 5x114.3 PCD and same 68.1 mm centre bore: wheels from Lotus Emira back bolt on and centre on Aston Martin DBS axe avant without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Lotus Emira back is compared with the one from Aston Martin DBS axe avant of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- !
≈9.5Jx20 ET54 · 295/30R20 — Check on the car
Compared with the original ≈7.5Jx20 ET42 on Aston Martin DBS axe avant: shock absorber side +37.4 mm, wheel arch side +13.4 mm, tyre diameter +0.8 %.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Aston Martin DBS axe avant (Ecrous - 14x2.00), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Aston Martin DBS axe avant on Lotus Emira back?