Yes, the hub is identical
Same 5x130 PCD and same 78.1 mm centre bore: wheels from Maxus EV80 Pro bolt on and centre on RAM Promaster without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Maxus EV80 Pro is compared with the one from RAM Promaster of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈6Jx16 ET66 · 195/75R16 — Fits like the original
Compared with the original ≈7Jx16 ET68 on RAM Promaster: shock absorber side −14.7 mm, wheel arch side −10.7 mm, tyre diameter −4.1 % : fit it with the original tyre size of RAM Promaster (215/75R16), not that of Maxus EV80 Pro.
Comparison for guidance only (estimated width). Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of RAM Promaster (Ecrous - 16x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from RAM Promaster on Maxus EV80 Pro?