Yes, the hub is identical
Same 5x100 PCD and same 54.1 mm centre bore: wheels from Mazda Mazda2 Hybrid bolt on and centre on Toyota Corolla US without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Mazda Mazda2 Hybrid is compared with the one from Toyota Corolla US of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✕
6Jx15 ET45 · 185/65R15 — Risk of rubbing
Compared with the original 6Jx15 ET33 on Toyota Corolla US: shock absorber side +12 mm, wheel arch side −12 mm, tyre diameter −2 % : fit it with the original tyre size of Toyota Corolla US (195/65R15), not that of Mazda Mazda2 Hybrid.
Check in detail
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Toyota Corolla US (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Toyota Corolla US on Mazda Mazda2 Hybrid?