FRENES

Wheels from Mitsubishi Colt on Dacia Sandero III: compatible?

Yes, with hub centric rings

Same 4x100 PCD, but the centre bore of the wheels from Mitsubishi Colt (67.1 mm) is larger than the hub of Dacia Sandero III (60.1 mm): you need 4 hub centric rings 67.1 → 60.1.

Rings 67.1 → 60.1

Mitsubishi Colt1988–1992Dacia Sandero IIIfrom 2020
PCD4x114.3 / 4x1004x100
Centre bore67.1 mm60.1 mm
ThreadEcrous - 12x1.50M12x1.50
Original wheels ≈5.5Jx13 ET46
≈5.5Jx14 ET46
≈6Jx14 ET46
≈6Jx15 ET46
≈6Jx16 ET37		 6Jx15 ET40

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Mitsubishi Colt is compared with the one from Dacia Sandero III of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • ≈6Jx15 ET46 · 195/50R15 — Check on the car

    Compared with the original 6Jx15 ET40 on Dacia Sandero III: shock absorber side +6 mm, wheel arch side −6 mm, tyre diameter −7.3 % : fit it with the original tyre size of Dacia Sandero III (185/65R15), not that of Mitsubishi Colt. Comparison for guidance only (estimated width). Check in detail

  • ≈5.5Jx13 ET46 · 175/70R13

    Dacia Sandero III has no 13-inch original wheel in our data: check the approved fitments and caliper clearance.

  • ≈5.5Jx14 ET46 · 175/65R14

    Dacia Sandero III has no 14-inch original wheel in our data: check the approved fitments and caliper clearance.

  • ≈6Jx14 ET46 · 185/60R14

    Dacia Sandero III has no 14-inch original wheel in our data: check the approved fitments and caliper clearance.

  • ≈6Jx16 ET37 · 195/55R16

    Dacia Sandero III has no 16-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Dacia Sandero III (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Dacia Sandero III on Mitsubishi Colt?