FRENES

Wheels from Mitsubishi Outlander IV on Renault 5 E-Tech: compatible?

Yes, the hub is identical

Same 5x114.3 PCD and same 66.1 mm centre bore: wheels from Mitsubishi Outlander IV bolt on and centre on Renault 5 E-Tech without rings. You still need to check the offset and tyres, detailed below.

Mitsubishi Outlander IVfrom 2025Renault 5 E-Techfrom 2024
PCD5x114.35x114.3
Centre bore66.1 mm66.1 mm
ThreadM12x1.25M12x1.50
Original wheels 7.5Jx18 ET35
8Jx20 ET35		 ≈6Jx18 ET38

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Mitsubishi Outlander IV is compared with the one from Renault 5 E-Tech of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 7.5Jx18 ET35 · 235/60R18 — Check on the car

    Compared with the original ≈6Jx18 ET38 on Renault 5 E-Tech: shock absorber side +16.1 mm, wheel arch side +22.1 mm, tyre diameter +10 % : fit it with the original tyre size of Renault 5 E-Tech (195/55R18), not that of Mitsubishi Outlander IV. Comparison for guidance only (estimated width). Check in detail

  • 8Jx20 ET35 · 255/45R20

    Renault 5 E-Tech has no 20-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Renault 5 E-Tech (M12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Renault 5 E-Tech on Mitsubishi Outlander IV?