A Mitsubishi Outlander IV (from 2025) uses a 5x114.3 PCD and a centre bore of 66.1 mm.
Any wheel must match the vehicle's PCD exactly: there is no tolerance, unless you use a PCD adapter.
Centre bore: the wheel must have a centre bore of 66.1 mm or more. If it is larger (as with most aftermarket wheels), add a hub centric ring wheel centre bore → 66.1 mm.
Offset: the original is ET35. Compare your future wheel with the offset calculator (your vehicle is already selected) to see how many millimetres further in or out it will sit.
Fixings: thread M12x1.25, tightened to 113 Nm. The nuts or bolts must have the same seat (conical, spherical or flat) as the wheel.
Tyres: original fitment is 235/60R18, 255/45R20. For another size, check the diameter difference with the equivalence calculator (under 3 % recommended).
Generations of the Mitsubishi Outlander
Previous generation: Mitsubishi Outlander (2003–2007) — same 5x114.3 bolt pattern and same centre bore: original wheels swap between the two generations; check offset and diameter.
The original specs vary with the year, trim or wheel size. Identify your version from the tyre size marked on the sidewall.
Version
PCD
Centre bore
Wheel
Offset
Tyre
Version 1
5x114.3
66.1 mm
7.5Jx18
ET35
235/60R18
Version 2
5x114.3
66.1 mm
8Jx20
ET35
255/45R20
Vehicles with the same PCD and centre bore
Same 5x114.3 PCD and same 66.1 mm centre bore: wheels from these vehicles bolt on and centre on a Mitsubishi Outlander IV without rings. Offset, width, diameter and caliper clearance still need checking.
These vehicles also use 5x114.3 but with a different centre bore: their wheels need a hub centric ring if their centre bore is larger than 66.1 mm, and will not fit if it is smaller.
A Mitsubishi Outlander IV (from 2025) has a PCD of 5x114.3: 5 studs or bolts spaced around a circle 114.3 mm in diameter.
Does a Mitsubishi Outlander IV need a hub centric ring?
The centre bore (hub diameter) of a Mitsubishi Outlander IV is 66.1 mm. A wheel with a larger centre bore is fitted with a hub centric ring that brings it down to the hub diameter. A wheel with a smaller centre bore cannot be fitted.
What offset (ET) for a Mitsubishi Outlander IV?
The recorded original offset is ET35 depending on the version and wheel size. A lower ET pushes the wheel outwards, a higher ET pulls it inwards: check wheel well and caliper clearance before making any change.
What tightening torque for the wheels of a Mitsubishi Outlander IV?
The specified tightening torque is 113 Nm for M12x1.25 fixings. Tighten in a criss-cross pattern with a torque wrench and check the tightness again after about fifty kilometres.
Which vehicles have the same PCD as a Mitsubishi Outlander IV?
With the same PCD (5x114.3) and the same centre bore (66.1 mm), these include: Mitsubishi Outlander, Dacia Bigster, Renault 4 E-Tech, Dacia Duster III. Offset, width and rim diameter still need checking for each vehicle.
Does a value look wrong, or is a version missing? Let us know, we check every report.
Cookies : we use audience measurement cookies (Google Analytics) and, if you accept, advertising cookies. You can change your mind at any time via “Manage cookies” at the bottom of the page. Learn more