FRENES

Wheels from Opel Corsa E on Holden Barina 4 trou: compatible?

Yes, with hub centric rings

Same 4x100 PCD, but the centre bore of the wheels from Opel Corsa E (65.1 mm) is larger than the hub of Holden Barina 4 trou (56.6 mm): you need 4 hub centric rings 65.1 → 56.6.

Rings 65.1 → 56.6

Opel Corsa E2014–2019Holden Barina 4 troufrom 2011
PCD4x100 / 4x1084x100
Centre bore65.1 mm56.6 mm
ThreadM12x1.50Ecrous - 12x1.50
Original wheels 6Jx15 ET39
≈6Jx16 ET38		 ≈6Jx15 ET39

≈: width estimated from the original tyre size.

Wheel by wheel: offset and tyres

Each original wheel from Opel Corsa E is compared with the one from Holden Barina 4 trou of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.

  • 6Jx15 ET39 · 185/65R15 — Fits like the original

    Compared with the original ≈6Jx15 ET39 on Holden Barina 4 trou: shock absorber side 0 mm, wheel arch side 0 mm, tyre diameter −2 % : fit it with the original tyre size of Holden Barina 4 trou (195/65R15), not that of Opel Corsa E. Comparison for guidance only (estimated width). Check in detail

  • ≈6Jx16 ET38 · 195/55R16

    Holden Barina 4 trou has no 16-inch original wheel in our data: check the approved fitments and caliper clearance.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Holden Barina 4 trou (Ecrous - 12x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Holden Barina 4 trou on Opel Corsa E?