FRENES

Wheels from Renault Alaskan on Nissan Navara: compatible?

No, the centre bore is too small

Same 6x114.3 PCD, but the centre bore of the wheels from Renault Alaskan (66.1 mm) is smaller than the hub of Nissan Navara (108 mm): they will not fit without being re-bored by a professional.

Renault Alaskanfrom 2016Nissan Navara1998–2004
PCD6x114.36x139.7 / 6x114.3
Centre bore66.1 mm108 mm
ThreadEcrous - 12x1.25Ecrous - 12x1.25
Original wheels 7Jx16 ET45 ≈7.5Jx15 ET10
≈7.5Jx16 ET25
≈8Jx16 ET45

≈: width estimated from the original tyre size.

Before fitting the wheels

An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Nissan Navara (Ecrous - 12x1.25), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.

And the other way round: wheels from Nissan Navara on Renault Alaskan?