FRENES

XPeng P7i PCD

from 2023
VERIFIED
⌀60.1
PCD5x112
Centre bore60.1 mm
Offset (ET)ET30
Fixing typeM14x1.50
Tightening torque110 Nm
Original tyres245/50R18
Hub centric rings 60.1 mm → Wheel spacers 5x112(partner link) Change PCD (PCD adapter)(partner link) Sheet for your mechanic

Fitting wheels on a XPeng P7i

A XPeng P7i (from 2023) uses a 5x112 PCD and a centre bore of 60.1 mm. Any wheel must match the vehicle's PCD exactly: there is no tolerance, unless you use a PCD adapter.

  • PCD: 5x112 required. See all vehicles with 5x112.
  • Centre bore: the wheel must have a centre bore of 60.1 mm or more. If it is larger (as with most aftermarket wheels), add a hub centric ring wheel centre bore → 60.1 mm.
  • Offset: the original is ET30. Compare your future wheel with the offset calculator (your vehicle is already selected) to see how many millimetres further in or out it will sit.
  • Fixings: thread M14x1.50, tightened to 110 Nm. The nuts or bolts must have the same seat (conical, spherical or flat) as the wheel.
  • Tyres: original fitment is 245/50R18. For another size, check the diameter difference with the equivalence calculator (under 3 % recommended).

Vehicles with the same PCD and centre bore

Same 5x112 PCD and same 60.1 mm centre bore: wheels from these vehicles bolt on and centre on a XPeng P7i without rings. Offset, width, diameter and caliper clearance still need checking.

XPeng G9 from 2022 XPeng P7 from 2020

Will wheels from another vehicle fit your P7i?

Choose the vehicle the wheels come from: we compare the hub, then each original wheel to the millimetre.

Frequently asked questions

What is the PCD of a XPeng P7i?

A XPeng P7i (from 2023) has a PCD of 5x112: 5 studs or bolts spaced around a circle 112 mm in diameter.

Does a XPeng P7i need a hub centric ring?

The centre bore (hub diameter) of a XPeng P7i is 60.1 mm. A wheel with a larger centre bore is fitted with a hub centric ring that brings it down to the hub diameter. A wheel with a smaller centre bore cannot be fitted.

What offset (ET) for a XPeng P7i?

The recorded original offset is ET30. A lower ET pushes the wheel outwards, a higher ET pulls it inwards: check wheel well and caliper clearance before making any change.

What tightening torque for the wheels of a XPeng P7i?

The specified tightening torque is 110 Nm for M14x1.50 fixings. Tighten in a criss-cross pattern with a torque wrench and check the tightness again after about fifty kilometres.

Which vehicles have the same PCD as a XPeng P7i?

With the same PCD (5x112) and the same centre bore (60.1 mm), these include: XPeng G9, XPeng P7. Offset, width and rim diameter still need checking for each vehicle.

Does a value look wrong, or is a version missing? Let us know, we check every report.