Yes, the hub is identical
Same 5x127 PCD and same 71.6 mm centre bore: wheels from Chrysler Pacifica bolt on and centre on Dodge Charger without rings. You still need to check the offset and tyres, detailed below.
≈: width estimated from the original tyre size.
Wheel by wheel: offset and tyres
Each original wheel from Chrysler Pacifica is compared with the one from Dodge Charger of the same diameter: how much closer the wheel gets to the shock absorber or how far it sticks out of the wheel arch, and whether the tyre keeps the same overall diameter.
- ✓
≈7.5Jx18 ET51 · 235/60R18 — Fits like the original
Compared with the original ≈7.5Jx18 ET49 on Dodge Charger: shock absorber side +2 mm, wheel arch side −2 mm, tyre diameter +1.7 %.
Comparison for guidance only (estimated width). Check in detail
- ?
≈7.5Jx17 ET51 · 235/65R17
Dodge Charger has no 17-inch original wheel in our data: check the approved fitments and caliper clearance.
Before fitting the wheels
An identical hub is not enough: offset, width and diameter change the position of the wheel, and larger calipers can touch a smaller wheel. Original wheels often use bolts or nuts with a specific seat: keep the fixings intended for the wheel, with the thread of Dodge Charger (Ecrous - 14x1.50), tightened to the torque shown on its vehicle page. Finally, check that the size is among the approved fitments for your vehicle. This comparison is for guidance only: have the fitting approved by a professional.
And the other way round: wheels from Dodge Charger on Chrysler Pacifica?